12 41 020 Removing and installing/replacing starter (S65)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Remove idle actuator mounting.

Fig 1: Locating Idle Actuator Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug (1) and remove.

Unfasten nut.

Tightening torque 12 41 1AZ .

Remove battery positive lead (2).

Fig 2: Identifying Plug And Battery Positive Lead

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Release screws (2).

Tightening torque 12 41 2AZ .

Pull starter motor out of transmission mount and remove.

Fig 3: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation

Check starter pinion and ring gear for damage, replace damaged parts if necessary.

Add final details to vehicle.