13 62 610 Replacing pulse generator on crankshaft/transmission (S65)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Read out fault memory of DME control unit; if necessary, work through test schedules
Switch off ignition
REMOVE UNDERBODY PROTECTION
Remove REINFORCEMENT PLATE

Release screws (1).

Remove cover.

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector and remove.

Release screw (1).

Remove pulse generator.

Fig 2: Identifying Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Now clear the fault memory.

Add final details to vehicle.