13 62 601 Replacing pulse generator on left inlet camshaft (S65)

WARNING: This page is about a different variant/trim than selected.

(cylinder bank 5 to 8)

Necessary preliminary tasks

Read out fault memory of DME control unit; if necessary, work through test schedules
Switch off ignition
Remove INTAKE FILTER HOUSING
Remove left ignition coil cover

Release plug connector (1) and pull off.

Release screw.

Remove pulse generator (2).

Installation

Replace sealing ring and coat with antiseize agent.

Tightening torque, 13 62 5AZ

Fig 1: Identifying Plug Connector And Pulse Generator

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Now clear the fault memory.