13 54 544 Removing and installing/replacing right Hall sensor (S65)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Read out fault memory of DME control unit
Switch off ignition
Remove INTAKE AIR MANIFOLD
Remove SECONDARY-AIR PUMP
Release and raise cable duct for engine wiring harness; for information, refer to REMOVING ENGINE WIRING HARNESS

Unlock and disconnect plug-in contact in wiring harness (not on sensor).

Release screws and detach Hall sensor towards front.

Installation:

Make sure Hall sensor is installed in correct position.

Assemble engine.

Fig 1: Identifying Hall Sensor With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: After performing work on the throttle valve system (throttle valve assembly, servomotor, Hall sensor), it is absolutely essential to carry out a throttle valve actuator system test with the BMW diagnosis system!

Function selection:

Complete vehicle
Drive
Engine electronics
Air supply
Throttle valves
Throttle valve actuator

NOTE: Check stored fault messages
Clear fault memory