13 62 605 Replacing pulse generator on right exhaust camshaft (S65)

WARNING: This page is about a different variant/trim than selected.

(cylinder bank 1 to 4)

Necessary preliminary tasks

Read out fault memory of DME control unit; if necessary, work through test schedules
Switch off ignition
Release and raise coolant expansion tank. Do not kink hoses.
Remove right ignition coil cover

Release plug connector (1) and pull off.

Release screw.

Remove pulse generator (2).

Installation

Aluminum screws must always be replaced.

Replace sealing ring and coat with antiseize agent.

Tightening torque, 13 62 5AZ

Fig 1: Identifying Plug Connector And Pulse Generator

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Now clear the fault memory.