64 11 868 Removing and installing/replacing servodrive for defrosting flap (right)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Servomotors must be re-addressed in the event of replacement!
Addressing can only be carried out with the BMW diagnosis system.
Service functions:

Body
Heating and A/C function
Flap motors
Re-address flap motors

Necessary preliminary tasks:

Remove GLOVEBOX WITH HOUSING

NOTE: For purposes of clarity, the following graphics show the heater/air conditioner removed.

Unfasten plug connection (1) and disconnect.

Release screws (2).

Remove servodrive at side.

Installation:

Do not twist teeth of servodrive.

Fig 1: Identifying Plug Connection With Screws

Courtesy of BMW OF NORTH AMERICA, INC.