64 11 377 Removing and installing/replacing heater/air conditioner operator unit (version without CCC/ASK)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) !

NOTE: Car Communication Computer (CCC) Audio System Kontroller/Controller (ASK)

Lever out heater/air conditioner operator unit (1) with special tool 00 9 340 and pull.

Fig 1: Removing Heater/Air Conditioner Operator Unit With Centre Console Switch Cluster And Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect associated plug connections.

Remove heater/air conditioner operator unit (1) complete with center console switch cluster (2) and trim (3).

Replacement

Carefully unclip operator unit trim (1) at inner retaining points (2) only.

IMPORTANT: Risk of damage to operator unit (3)!

Fig 2: Identifying Clip Operator Unit Trim And Inner Retaining Points

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully unclip operator unit trim (1) at outer retaining points (2) only.

Remove trim (1) from operator unit (3).

Fig 3: Identifying Clip Operator Unit Trim And Outer Retaining Points

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement

Carry out Vehicle programming and encoding.