86 10... Replacing position light

WARNING: This page is about a different variant/trim than selected.

Unclip cover (1) on side recess (arrow).

Fig 1: Removing Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Pull flat connector (1) from flat contact.

Fig 2: Identifying Flat Connectors

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out cable (1) completely.

CAUTION: Before drilling out rivet heads, drive in rivet pins with a punch.
Drill out rivet heads (2) and remove position light housing from front.

Fig 3: Identifying Cable And Rivet Heads

Courtesy of BMW OF NORTH AMERICA, INC.