86 10... Removing rear supports and bracket

WARNING: This page is about a different variant/trim than selected.

Release screws (1) and remove rear support (2) from bracket (3).

Installation

Tightening Torque,

Fig 1: Identifying Rear Support Of Bracket With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cable holders (1) from bracket (2). Release screws (3) on left and right sides of bracket (2). Drill out rivets (4) from underside of platform. Drill out rivets (5) from upper side of platform.

Installation

Tightening Torque,

Refer to TIGHTENING TORQUE 86 10 27AZ.

Fig 2: Identifying Bracket With Cable Holder, Screws And Rivets

Courtesy of BMW OF NORTH AMERICA, INC.

Installation

Feed cable for rear light (1) through opening (2). Fit cable holders (4) in holes (3).

Fig 3: Fitting Cable Holders In Holes

Courtesy of BMW OF NORTH AMERICA, INC.