86 10... Disassembly of loading ramp frame/disassembly of rail, left/right

WARNING: This page is about a different variant/trim than selected.

NOTE: Two persons are required to disassemble the loading ramp frame.
Disassembly of license plate mounting plate
REFER TO 86 10... DISASSEMBLY OF LICENSE PLATE
mounting plate.
Disassembly of pull rod

Release screws (1) of loading ramp frame (2) on cross-strut (3).

Installation

Tightening Torque,

Refer to TIGHTENING TORQUE 86 10 7AZ.

Fig 1: Identifying Screws Of Loading Ramp Frame On Cross-Strut

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1, 2) on left and right sides of loading ramp frame (3).

Installation

Use new self-locking nuts.

Tightening Torque,

Refer to TIGHTENING TORQUE 86 10 8AZ.

Fig 2: Identifying Loading Ramp Frame With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1, 2, 3).

Installation

Use new self-locking nuts.

Tightening Torque,

Refer to TIGHTENING TORQUE 86 10 9AZ.

Fig 3: Identifying Loading Ramp Frame Screws

Courtesy of BMW OF NORTH AMERICA, INC.