36 11 105 Removing and installing RDC control unit

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks

Press sound-insulating material (1) to one side slightly.

Release screw (2) and carefully swing out control unit holder a little.

Fig 1: Pressing Sound-Insulating Material

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Press lug (2) in direction of arrow and pull out control unit (3) towards top.

Fig 2: Pressing Lug

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement