34 41 000 Removing and installing/replacing handbrake lever

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Disconnect BATTERY NEGATIVE LEAD
Remove AIRBAG CONTROL UNIT

NOTE: If the parking brake lever is replaced, the handbrake lever grip must also be replaced.

Lock adjuster unit (ASZE).

Actuate parking brake lever. Connect special tool 32 1 030 LEVER . Press stop (1) of adjusting spring back to such an extent that retaining hook (2) engages in stop (1).

Installation:

Unlock adjuster unit (ASZE).

Lever out restraining hook (2) with a suitable screwdriver.

Restraining hook (2) must detach from stop (1) of adjusting spring.

Fig 1: Removing Hook From Adjusting Spring

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 34 41 5AZ .

Remove bracket for center console (2).

Fig 2: Identifying Centre Console Bracket With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect cable (1) from handbrake check switch.

Unclip cable bracket (2) at point (3).

Remove cable bracket and place forward.

Fig 3: Identifying Handbrake Check Switch Cable And Cable Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Press retainer (1) in balance arm (2) forward in direction of arrow.

Detach handbrake Bowden cables (3) from balance arm (2).

Fig 4: Pressing Retainer In Balance Arm

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (1) and remove parking brake lever (2).

Installation:

Replace self-locking nuts.

Tightening torque 34 41 1AZ .

Parking brake lever and adjustment unit (ASZE) are only exchanged completely as a single unit.

Fig 5: Identifying Parking Brake Lever With Nuts

Courtesy of BMW OF NORTH AMERICA, INC.