51 13 316 Removing and installing/replacing trim strip on roof gutter at left or right
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Make sure that body is not damaged.
Starting at front, release trim strip (1) with special tool 009317 from clips (2).
Installation:
To avoid leaks and noises, check all clips (2) for visible damage.
If necessary, replace faulty clips (2).
Align clips (2) on body and fit trim strip (1).
Installation:
Seals (1) must not be damaged.
IMPORTANT:
- Carry trim strip by its middle section only (risk of damage)
- Perform installation work with a second person helping
- Prepositioning of trim strip
- Ensure drip molding runs parallel to side frame (risk of breakage)