51 45 380 Removing and installing (replacing) right decorative strip on dashboard
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Risk of damage!
A hard disk is installed in the Car Information Computer (CIC).
Carry out mechanical work on the CIC and adjacent components with care.
Avoid subjecting the CIC to shaking/shocks.
IMPORTANT:
Risk of damage!
Do not turn special tool 00 9 317 when levering out and pay attention to pressure points.
Lever out decorative strip (2) from left side beginning at retaining points (1) with special tool 00 9 317.
Disconnect associated plug connection and remove decorative strip (2).
Do not turn special tool 00 9 317 when levering out and pay attention to pressure points.
Lever out decorative strip (2) from left side beginning at retaining points (1) with special tool 00 9 317.
Disconnect associated plug connection and remove decorative strip (2).
Installation:
Clips (1) must be seated in associated mountings.
If necessary, remove clips (1) remaining on decorative strip.
Replace damaged clips (1):
- Turn clip (1) with screwdriver to left by approx. 90°.
- Lever out clip (1) from below.
Replacement