51 31... Removing and installing/replacing retaining strip for cowl panel cover

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Remove COVER for cowl panel

IMPORTANT: Retaining strip (2) has an aluminum profile insert (1).
Carefully wind out retaining strip (2) (windscreen breakage).

4 Glue bead

5 Pinched butyl

6 Contact surfaces

Fig 1: Removing Retaining Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clean cutout.

Pay attention to center marking on retaining strip (1) and windscreen.

Insert positioner (2) for retaining strip (1) must be removed after it has been fitted on the windscreen but before the windscreen itself is installed.

Replacement of retaining strip without windscreen removal

If adhesive has managed to get onto retaining strip (1), this area must be cut out partially.

To facilitate installation, coat and body cutout with water.

Replacement of retaining strip with removed or new windscreen

Fig 2: Identifying Rubber Frame, Aluminum Strip, Contact Surfaces And Butyl

Courtesy of BMW OF NORTH AMERICA, INC.

Fit rubber frame (1).

3 Aluminum strip

4 Contact surfaces

5 Butyl