51 14 000 Removing and installing/replacing front BMW badge

To avoid damaging the paintwork on the engine hood/bonnet, tape off edge areas (1) to sides of guide pins.

So as not to subject the BMW badge to excessive deformation, lever out the badge with special tool 009325 at guide pins (2).

Fig 1: Removing BMW Badge Using Special Tool (00 9 326) At Guide Pins

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

The following parts must not be damaged or missing, replace if necessary:

1. Badge
2. Guide pins
3. Grommets

Adhesive tape (4)

Fig 2: Identifying Badge, Guide Pins And Grommets

Courtesy of BMW OF NORTH AMERICA, INC.