61 31 270 Replacing switch for reversing light

WARNING: This page is about a different variant/trim than selected.

NOTE: The installation location of the reversing light switch can vary, depending on the transmission model.

Necessary preliminary tasks

Version A:

Disconnect plug connection (1).

Release switch for reversing light (2).

Tightening torque 61 31 2AZ .

Fig 1: Identifying Plug Connection And Switch For Reversing Light (Version A)

Courtesy of BMW OF NORTH AMERICA, INC.

Version B:

Disconnect plug connection (1).

Release switch for reversing light (2).

Tightening torque 61 31 2AZ .

Fig 2: Identifying Plug Connection And Switch For Reversing Light (Version B)

Courtesy of BMW OF NORTH AMERICA, INC.