61 13... Crimping Micro Quadlock System contacts (MQS)

WARNING: This page is about a different variant/trim than selected.

To crimp MPQ contacts, use pliers 61 4 321 (1) in conjunction with crimping head 61 4 324 (2) from crimping set 614320.

NOTE: Pliers (1) open automatically as far as they will go when handles are pressed together.

Fig 1: Identifying Hand Pliers With Crimping Head (61 4 324)

Courtesy of BMW OF NORTH AMERICA, INC.

Open pliers (1).

Fold up contact carrier (2).

Insert MQS contact (3) in contact carrier (2).

Fold back contact carrier (2).

Fig 2: Identifying Pliers, MQS Contact And Contact Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Follow procedure for CUTTING AND STRIPPING INSULATION from cables.

Close pliers (1) one notch.

Insert stripped cable (2).

Close pliers (1) fully.

Fig 3: Cutting And Stripping Insulation From Cables

Courtesy of BMW OF NORTH AMERICA, INC.

Open pliers (1).

Open contact carrier (2) gently and carefully remove MQS contact.

NOTE: CHECK CONTACT FOR CORRECT CRIMPING .

Fig 4: Opening Contact Carrier Gently

Courtesy of BMW OF NORTH AMERICA, INC.