61 13... Crimping Micro Power Quadlock contacts (MPQ)

WARNING: This page is about a different variant/trim than selected.

To crimp MPQ contacts, use pliers 61 4 321 (1) in conjunction with crimping head 61 4 325 (2) from crimping set 614320.

NOTE: Pliers (1) open automatically as far as they will go when handles are pressed together.

Fig 1: Identifying Hand Pliers With Crimping Head (61 4 325)

Courtesy of BMW OF NORTH AMERICA, INC.

Open pliers (1).

NOTE: Place contact (2) with utmost care in designated nest (observe cable cross-section) in crimping head (3). Make sure it is exactly positioned.

Place MPQ contact (2) in crimping head (3).

Close pliers (1) one notch.

Fig 2: Identifying Hand Pliers With Crimping Head And MPQ Contact

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Follow procedure for CUTTING AND STRIPPING INSULATION from cables.

Insert stripped cable (2).

Close pliers (1) fully.

Open pliers (1) and remove cable (2).

NOTE: CHECK CONTACT FOR CORRECT CRIMPING .

Fig 3: Cutting And Stripping Insulation From Cables

Courtesy of BMW OF NORTH AMERICA, INC.