61 67 083 Removing and installing/replacing high-pressure nozzle of headlight washer system on left or right (M3)

Necessary preliminary tasks 

• Remove FRONT BUMPER TRIM .

To prevent excessive escape of washer fluid, seal off end of high-pressure line with special tool 13 3 010 TERMINAL .

Catch any escaping washer fluid if necessary.

Fig 1: Identifying Special Tool 13 3 010

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock catches (1) and remove high-pressure nozzle (2) towards rear from headlight arm (3).

Raise retaining clip (4) in direction of arrow and detach high-pressure line (5) from high-pressure nozzle (2).

Fig 2: Raising High Pressure Line Retaining Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Keep plug connection for high-pressure nozzle (2) and high-pressure line (5) clean and free from grease.

Make high-pressure line (5) and high-pressure nozzle (2) are correctly seated and engaged on high-pressure nozzle (2) and headlight arm (3) respectively.

Carry out a function test before fitting bumper trim.

If necessary, top up washer fluid.