84 10 050 Removing and installing (replacing) USB hub
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .
Necessary preliminary tasks
- Remove LEFT FRONT SEAT
- Remove FRONT LEFT ENTRANCE COVER STRIP
- Fold back carpet for passenger compartment at front left in direction of travel
Remove USB hub protective socket (1) from footwell insert (2).
Unlock catches (3) with a suitable tool and remove USB hub protective socket cover (5).
Installation:
Make sure USB hub protective socket cover (5) engages correctly on USB hub protective socket lower section.
Seal (4) must not be damaged; if necessary, replace USB hub protective socket cover (5).
Remove USB hub (1) from USB hub protective socket lower section (2).
Installation:
Make sure rubber grommet (4) is correctly seated on USB hub protective socket lower section (2).
Disconnect plug connection (3).