61 35 950 Removing and installing (replacing) control unit for comfort access system

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks

Release screws (1) and pull back device holder (2).

Fig 1: Pulling Back Device Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Unlock catch (2) in direction of arrow and remove control unit for comfort access system (3) upwards from device carrier (4).

Fig 2: Removing Catch

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement

Carry out vehicle programming and encoding.