61 12 210 Replacing wiring harness in left or right rear door
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks
- Close rear side window completely
- Remove REAR DOOR TRIM PANEL
- Remove REAR ACOUSTIC INSULATION
Unlock plug connection (1) on door lock and disconnect.
Unlock plug connection (2) on power window and disconnect.
Disconnect plug connection (3) on outside door handle light.
Unclip door wiring harness at points (4).
Installation:
Make sure door wiring harness is correctly laid.
Release screw (1), fold door wiring harness plug on B-pillar (2) downwards slightly and remove.
Unlock plug connection behind and disconnect.
Pull rubber grommet (3) out of rear door.
Feed out door wiring harness towards front to B-pillar and remove.