64 52 A/C compressor
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - A/C COMPRESSOR
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Refrigerant lines to A/C compressor | E36/7 M54, E36/7 S54, E38, E39, E46, E52, E53, E60, E61, E63, E64, E65, E66, E67, E83, E85, E87, E90, E91, E92, E93 | M8 | 20 Nm | |
| 2AZ Filler plug, A/C compressor | E36, E38, E39, E46, E52, E53, E60, E61, E63, E64, E65, E66, E67, E83, E85, E87, E90, E91, E92, E93 | 30±1 Nm | ||
| 3AZ A/C compressor to carrier | M67TU, M54, N62, S85, N54 | M8 | 21 Nm | |
| N45, N46, M47T2, M57TU, M57T2 | M8 | 19 Nm | ||
| N52K | M8 x 87 | Replace aluminium screw/bolt Jointing torque Torque angle |
10 Nm 180±15° |
|
| N52K | M8 x 52 | Replace aluminium screw/bolt Jointing torque Torque angle |
10 Nm 90±15° |
|
| N52 | M8 x 87 | Replace aluminium screw/bolt Jointing torque Torque angle |
10 Nm 180±15° |
|
| N53 | M8 x 52 | Replace aluminium screw/bolt Jointing torque Torque angle |
10 Nm 90±15° |
|
| N53 | M8 x 87 | Replace aluminium screw/bolt Jointing torque Torque angle |
10 Nm 180±15° |
|
| E85 S54, E86 S54 | 20 Nm | |||
| 4AZ Belt pulley/hub to A/C compressor | M47T2 | 35±5 Nm | ||
| 5AZ Bracket, A/C compressor to lower crankcase | N54 | 19 Nm | ||
| 6AZ Cable holder to A/C compressor | M47T2 | 3 Nm |