33 55 000 Removing and installing/replacing rear anti-roll bar
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
M3:
When installing the anti-roll bar, make sure the two rubber mount halves are correctly installed and correctly engaged on both sides (in the retaining bracket).
When installing the anti-roll bar, make sure the two rubber mount halves are correctly installed and correctly engaged on both sides (in the retaining bracket).
Necessary preliminary tasks
- Remove both REAR COIL SPRINGS
- Remove LEFT CONTROL ARM ON WHEEL CARRIER
- Remove both ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR
- Lower REAR AXLE SUPPORT
NOTE:
To simplify the picture, anti-roll bar removal is shown on the removed rear axle.
Release screws (1).
Remove both RUBBER MOUNTS FROM ANTI-ROLL BAR .
Turn anti-roll bar (2) and remove sideways.
Installation:
Check both RUBBER MOUNTS FOR DAMAGE and replace if necessary.
Tightening torque 33 55 1AZ .
After installation
- Bleed BRAKING SYSTEM