33 00... Rear axle: wheel/chassis alignment check must be carried out after the following work
WARNING: This page is about a different variant/trim than selected.
A wheel/chassis alignment check See 3200150 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or 3200155 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD must be carried out after the following work:
- Release of following screw/bolt connections:
- Camber arm to rear axle carrier/wheel carrier
- Trailing arm to rear axle carrier/wheel carrier
- Guide arm to rear axle carrier
- Toe arm to rear axle carrier/wheel carrier
- Control arm to rear axle carrier
- Replacement of following parts:
- Rear axle carrier
- Camber arm/rubber mount/ball joint
- Trailing arm/rubber mount
- Guide arm
- Wheel carrier/rubber mount/ball joint
- Toe arm
- Control arm