LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> M3 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 47 (Rear Axle - Repair - E90) >> General >> 00...... Raising vehicle with trolley jack

00...... Raising vehicle with trolley jack

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Observe the following trolley-jack-related instructions: 
  1. Use only BMW-distributed/approved trolley jacks which have rubber plate contact points.
    Fig 1: Identifying Trolley Jack With Rubber Plate
    G04725307Courtesy of BMW OF NORTH AMERICA, INC.
  2. Trolley jacks must be regularly serviced and always checked for functional reliability before they are used!
  3. Check the rubber plate on the trolley jack prior to each use, replacing if necessary.
WARNING: The vehicle may be raised with a trolley jack only  at the following jacking points!
  1. Car jacking point on reinforcement strut (rear-wheel drive)
  2. Side car jacking points
  3. Rear differential
    Fig 2: Identifying Car Jacking Points
    G04725308Courtesy of BMW OF NORTH AMERICA, INC.

    Risk of damage: It is not permitted to raise the vehicle at the rear differential cover!

  1. Car jacking point on front axle carrier (all-wheel drive)
Fig 3: Identifying Car Jacking Point On Front Axle Carrier (All-Wheel Drive)
G04725309Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals