33 32 195 Replacing rubber mount for camber arm in rear axle support

WARNING: This page is about a different variant/trim than selected.

WARNING: Risk of burns!
This work may only be carried out on an exhaust system which has cooled down.

Necessary preliminary tasks

Removing rubber mount

Pull out and remove rubber mount with special tools 33 4 462, 33 4 464, 33 4 463, 33 4 466 and 33 4 465.

Fig 1: Pulling Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

Installing new rubber mount

Pull together rubber mount with special tools 33 4 455, 33 4 456, 33 4 452 and 33 4 451.

Fig 2: Installing Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

Draw rubber mount into rear axle support so that slot (1), rubber mount center point and notch (2) form a line.

Fig 3: Identifying Rubber Mount Slot And Notch

Courtesy of BMW OF NORTH AMERICA, INC.

Draw rubber mount into rear axle support as far as possible using special tools 33 4 461, 33 4 463, 33 4 466 and 33 4 465.

Remove special tool 33 4 450 DEVICE and draw in rubber mount as far as it will go.

Fig 4: Installing Rubber Mount Into Rear Axle Support Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

After installation