33 33 101 Replacing two rubber mounts (rear) for rear axle carrier

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

If necessary, assemble special tool 33 4 140 DEVICE , 33 4 142 and 33 4 147 as shown.

If necessary, screw new thrust pieces 33 4 149 with countersunk screws on special tool 33 4 140 DEVICE .

Fig 1: Assembling Special Tools (33 4 140, 33 4 142 And 33 4 147)

Courtesy of BMW OF NORTH AMERICA, INC.

Coat top edge of rubber mount with Circo Light.

Fit special tool 33 4 441 on rubber mount in such a way that edge of rubber mount disappears in special tool.

Oil special tool 33 4 436 slightly before use.

Fig 2: Fitting Special Tool (33 4 441) On Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Align special tool 33 4 140 DEVICE by way of openings in rubber mount.

NOTE: Ensure it is correctly supported on bearing bushing of rear axle carrier.

Pull rubber mount with special tools 33 4 436, 33 4 437, 33 4 140 DEVICE and 33 4 431 out of bearing bush.

Installation:

Coat new rubber mount with Circo Light.

Insert special tool 33 4 444 in opening on rear axle carrier to avoid damaging the rear axle carrier when drawing in the rubber mount.

Oil special tool 33 4 434 slightly before use.

If necessary, assemble special tool 33 4 442, 33 4 443, 33 4 435 and 33 4 434 as shown.

Align rubber mount by way of arrow to direction of travel.

Draw in rubber mount as far as it will go.

Fig 3: Aligning Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

After installation