23 12 089 Replacing radial shaft seal for selector shaft (GS6-53BZ/DZ): Notes

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: After completion of work, check TRANSMISSION OIL LEVEL .
Use only approved MANUAL TRANSMISSION - OPERATING FLUIDS .
Failure to comply with this instruction will result in serious damage to the transmission.

Necessary preliminary tasks:

Shift transmission into 2nd gear
Unflange propeller shaft from transmission.

Tasks are described in Removing propeller shaft.

Lever retaining ring (1) out of groove with a small screwdriver.

Slide locking ring (1) towards rear.

Drive out cylinder pin (2).

Fig 1: Sliding Locking Ring Towards Rear

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in special tool 230210 until it is firmly connected with radial seal (1).

Pull out radial seal with special tool 230210.

Fig 2: Connecting Radial Shaft Seal Using Special Tool (23 0 210)

Courtesy of BMW OF NORTH AMERICA, INC.

Coat sealing lips of radial seal and selector shaft with transmission oil.

Drive in radial seal with special tool 230220.

Fig 3: Installing Radial Seal Using Special Tool (23 0 220)

Courtesy of BMW OF NORTH AMERICA, INC.