11 21 Crankshaft and Bearings
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - CRANKSHAFT AND BEARINGS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Increment wheel on crankshaft | S54 | M5 10.9 | Replace screws Jointing torque Torque angle |
5.0 Nm 45° |
| Increment wheel on crankshaft | M5 10.9 | Replace screws | 13 Nm | |
| Increment wheel on crankshaft | M5 8.8 | Replace screws | 5.5 Nm |