34 21 Rear Brake Discs E90
WARNING: This page is about a different variant/trim than selected.
REAR BRAKE DISCS SPECIFICATION
|
IMPORTANT:
New brake pads may only be fitted if the brake disc thickness is greater than the minimum brake disc thickness (MIN TH).
Minimum brake disc thickness during general inspection (GI): Nominal size thickness minus 2.4 mm (Not applicable to perforated brake discs and M vehicles) M vehicles and perforated brake discs: Nominal size thickness minus 1.6 mm Depending on: Engine type Transmission version Equipment specification (e.g. maximum load increase, chassis official-use, national version, etc.) different brake discs can be fitted The brake discs must always be assigned by way of the relevant vehicle identification number and the Electronic Parts Catalogue (ETK)! |
||
| Different thicknesses on brake linings | Max. mm | 0.01 |
| Max. machining limit per friction ring side (M vehicles and perforated brake discs must not be machined). Brake disc minimum thickness (MIN TH) must not be undershot. |
mm | 0.8 |
| Nominal size (diameter x thickness) | mm | 350x24 |
| Brake disk minimum thickness (MIN TH) stamped on brake disk body | mm | 22.4 |
| Nominal size (diameter x thickness) | mm | 336x22 |
| Nominal size (diameter x thickness) | mm | 324x22 |
| Brake disk minimum thickness (MIN TH) stamped on brake disk body | mm | 20.4 |
| Nominal size (diameter x thickness) | mm | 300x20 |
| Brake disk minimum thickness (MIN TH) stamped on brake disk body | mm | 18.4 |
| Nominal size (diameter x thickness) | mm | 296x10 |
| Brake disk minimum thickness (MIN TH) stamped on brake disk body | mm | 8.4 |
| Wear warning from residual lining thickness | mm | 3.7 |