11 25 Pistons with Rings and Pins S65
WARNING: This page is about a different variant/trim than selected.
PISTONS WITH RINGS AND PINS SPECIFICATION
| 1st groove | ||
| End clearance | mm | 0.15... 0.30 |
| Axial play | mm | 0.020... 0.060 |
| 2nd groove | ||
| End clearance | mm | 0.40... 0.60 |
| Axial play | mm | 0.020... 0.060 |
| 3rd groove | ||
| End clearance | mm | 0.1... 0.3 |
| Axial play | mm | cannot be measured |
PISTONS WITH RINGS AND PINS SPECIFICATION
| Piston and pin are paired to each other - replace together only. | ||
| Measuring point "A" (position) | mm | 14 |
| Piston diameter at measuring point "A" | ||
| Original (new dimension) | mm | 91.990 ± 0.01 |
| Oversize (new dimension) | mm | 92.190 ± 0.01 |
| Piston installation clearance (piston new) | mm | 0.000... 0.032 |
| Piston installation clearance (piston worn) | mm | 0.020... 0.047 |
| Permissible total wear tolerance between piston and cylinder (engine operated) | mm | 0.050 |