11 11 Engine Block, Cylinder Crankcase S65
WARNING: This page is about a different variant/trim than selected.
ENGINE BLOCK, CYLINDER CRANKCASE SPECIFICATION
| Bore stage 0 (1) | mm | 92.000 +0.014 | ||
| Bore stage 1 a) | mm | 92.200 +0.014 | ||
| Permitted out-of-round of cylinder bore a) | mm | 0.007 | ||
| Permitted conicity of cylinder bore a) | mm | 0.007 | ||
| Permissible total wear tolerance between piston and cylinder (engine operated) | mm | 0.15 | ||
|
||||