51 71 447 Removing and installing/replacing trim for cover on left or right side member (up to 08/09) (sedan)

Necessary preliminary tasks: 

• Detach wheel arch cover   from front/rear side member cover

Release bolts (1).

Unclip panel (1) at holders (2) in direction of arrow and remove.

Installation: 

Before installation, soak holders (1) in water.

If necessary, detach holders (1) from body and fit on panel (3).

If necessary, detach grommets (2) from holders (1) and place on body.

If necessary, replace faulty holders (1) and grommets (2).