51 71 039 Removing and installing/replacing front left or right wheel arch cover (rear section)
Necessary preliminary tasks:
- If necessary, remove front wheel
NOTE:
In event of further work, where possible, leave wheel arch cover on vehicle.
Wheel arch cover must not be cut.
In case of complete removal or replacement, release spring strut . See 33 53 000 REMOVING AND INSTALLING / REPLACING REAR LEFT OR RIGHT COIL SPRING .
Wheel arch cover must not be cut.
In case of complete removal or replacement, release spring strut . See 33 53 000 REMOVING AND INSTALLING / REPLACING REAR LEFT OR RIGHT COIL SPRING .
NOTE:
Front axle removed for purposes of clarity.
Release screws (1 and 2).
Release nuts (3) and loosen wheel arch cover (4) from installation position.
Installation:
Ensure wheel arch cover (4) is correctly seated.
Replacement:
- Modify sheet nuts (1)
Installation:
If necessary, replace faulty metal nuts (1).