51 71 ... Replacing convertible top compartment lid seal

Open rear end module.

Fig 1: Opening Rear End Module

Courtesy of BMW OF NORTH AMERICA, INC.

Release sheet screw (1) and thin sheet screw (2) on left and right.

Installation:

Make sure screws are installed in correct positions.

Fig 2: Identifying Sheet Screw And Thin Sheet Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Retract folding roof fully and open rear end cover.

IMPORTANT: Do not stretch, kink or crush seal.

Pull off seal (1) from left to right.

Installation:

Moisten seal with soapy water.

Carry out installation from left to right (check screw fastening points).

Fig 3: Pulling Off Seal

Courtesy of BMW OF NORTH AMERICA, INC.