51 41 000 Removing and installing left or right front door trim panel (convertible/coupe)

Special tools required: 

• 00 9 317 

See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .

Necessary preliminary tasks: 

• Remove decorative strip from door trim panel.  

Driver's side: 

• Remove rocker switch for side window operation  . See 61 31 115 REPLACING ROCKER SWITCH FOR SIDE WINDOW OPERATION (FRONT) .

Passenger side: 

• Remove cover on door handle  . 

Driver's side only: 

Release screws (1).

Tightening torque 51 41 1AZ, see 51 41 FRONT DOOR TRIM PANEL WITH ARMRESTS .

Passenger side only: 

Release screws (1).

Tightening torque 51 41 1AZ, see 51 41 FRONT DOOR TRIM PANEL WITH ARMRESTS .

Release clips (2) for door trim panel (1) with special tool 00 9 317 .

Carefully unclip door trim panel (2) at top from retainers (1).

Unhook Bowden cable (1) from door lock (2).

Disconnect all plug connections/cable holders and remove door trim panel.

Installation: 

If necessary, replace faulty clips.

Fit all clips with sealing ring.

Make sure clips are installed in correct position.

1. Grey clip
2. White clip
3. Red clip
   Fig 6: Identifying Sealing Ring And Clips

   Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

After assembling the door trim panel proceed as follows:

• Open door window.
• Lock with vehicle key.
• Check for ease-of-movement on retaining button linkage
• If necessary, align linkages