52 16 050 Removing or installing/replacing lumbar cushion on front seat (M3 sport seat)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Detach backrest cover in marked area.

Fig 1: Identifying Backrest Cover In Marked Area

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and detach quick connectors from red and green air hoses (1) and (2).

Installation:

Connections are coded against incorrect installation.

Replacement only:

Wrap air hose (green) in contact area with spring wire in fabric adhesive tape (risk of damage).

Fig 2: Identifying Red/Green Air Hoses

Courtesy of BMW OF NORTH AMERICA, INC.

Lift fleece tabs of lumbar support cushion carrier from plastic clips (1).

Installation:

Hook lumbar support cushion over second and fourth wire.

Disengage springs (2) from spring wire.

Fig 3: Lifting Fleece Tabs Of Lumbar Support Cushion Carrier From Plastic Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Feed out lumbar cushion carrier with lumbar cushion between backrest frame and spring wire.

Fig 4: Feeding Lumbar Cushion Carrier With Lumbar Cushion And Spring Wire

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check lumbar cushion at top (1) and bottom (2) for damage.

Check quick connectors (3) for damage.

Install air hoses without kinks.

Fig 5: Identifying Quick Connectors

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: