86 10... Replacing rear light

Release thumb screws (1), slide light guard (2) in direction of middle of car and tilt out towards rear.

Fig 1: Identifying Light Guard With Thumb Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Turn handwheel (1) counterclockwise in direction of arrow and remove base (2).

Fig 2: Turning Handwheel

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (1) and press rear light (2) out towards front.

Installation 

Use new self-locking nuts.

Tightening Torque,

Refer to TIGHTENING TORQUE 86 10 1AZ.

Fig 3: Identifying Rear Light With Mounting Nuts

Courtesy of BMW OF NORTH AMERICA, INC.