86 10... Replacing lashing plate and lashing eye

Releasing lashing eye

Pull spring bar (1) upwards in direction of arrow A. Slide lashing eye (3) in direction of arrow B and remove from lashing plate (2).

Fig 1: Pulling Spring Bar

Courtesy of BMW OF NORTH AMERICA, INC.

Release countersunk head screws (1) and remove lashing plate.

Installation 

Tightening torque,

Refer to TIGHTENING TORQUE 86 10 3AZ.

Fig 2: Identifying Countersunk Head Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Locking lashing eye

Position lashing eye (1) on circular openings on lashing plate (2). Press lashing eye (1) in direction of arrow A into lashing plate (2). In this position, slide lashing eye (1) in direction of arrow B. Spring bar (3) snaps in, anchors and secures lashing eye (1) in lashing plate (2).

Fig 3: Pressing Lashing Eye

Courtesy of BMW OF NORTH AMERICA, INC.