86 10... Removing wheel bearing

WARNING: This page is about a different variant/trim than selected.

The angular-contact ball bearings do not require maintenance and have lifetime lubrication. The bearings cannot be readjusted.

Remove brake drum,

Lever out both snap rings (1).

Installation

Replace expanded or damaged snap rings (1). Ensure correct seating.

Fig 1: Removing Snap Rings

Courtesy of BMW OF NORTH AMERICA, INC.

Press out wheel bearing with special tool 24 1 010.

CAUTION: Do not reuse old wheel bearing.

Fig 2: Pressing Wheel Bearing Using Special Tool (24 1 010)

Courtesy of BMW OF NORTH AMERICA, INC.

Place new wheel bearing (1) with lathe-turned end (2) in center of bore in brake drum (3).

Installation

Before pressing in new wheel bearing, check bearing seat for possible damage.

Make sure wheel bearing is not tilted when pressed in.

Fig 3: Identifying Brake Drum, Wheel Bearing With Lathe-Turned End

Courtesy of BMW OF NORTH AMERICA, INC.

Press in new wheel bearing (1) with special tool 23 2 150 and 33 1 374.

Fig 4: Pressing Wheel Bearing Using Special Tool (23 2 150) And (33 1 374)

Courtesy of BMW OF NORTH AMERICA, INC.