34 31 181 Removing and installing/replacing expansion tank for hydraulic brake actuation

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Read and comply with GENERAL INFORMATION .
Remove lower section of microfilter housing See 6431062 REMOVING AND INSTALLING/REPLACING LEFT LOWER MICROFILTER HOUSING SECTION or 6431063 REMOVING AND INSTALLING/REPLACING RIGHT LOWER MICROFILTER HOUSING SECTION

NOTE: Extract brake fluid out of expansion tank. Use a suction bottle used exclusively for drawing off brake fluid.

Do not reuse drawn out brake fluid.

Fig 1: Identifying Brake Cover, Supply Hose, Plug Connection And Fastener

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off supply hose (1) of clutch hydraulic system if necessary.

Unfasten plug connection (2) and disconnect.

Unlock quick-release fastener (3) and disconnect vacuum line.

Feed brake line out of rubber grommet and remove cover (4).

Unclip locking pin (1) from retaining lugs (2) and pull out locking pin.

Pull expansion tank in direction of arrow vertically out of brake master cylinder.

Fig 2: Pulling Locking Pin

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Check rubber plug in brake master cylinder for damage and replace if necessary.
Push the expansion tank vertically onto the master brake cylinder.

Fig 3: Pushing Expansion Tank Onto Master Brake Cylinder

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

BLEED BRAKING SYSTEM