51 22 280 Removing and installing/replacing door retainer on rear left or right door

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

NOTE: Secure rear door against falling closed.

Release screw (1).

Tightening torque 51 22 3AZ .

Remove seal (2).

Installation:

Seal (2) must not be damaged.

Make sure seal (2) is correctly seated.

Fig 1: Identifying Seal And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 51 22 4AZ .

Fig 2: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove door retainer (1) via cutout (2).

Fig 3: Identifying Door Retainer And Cutout

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of door retainer (3) must not be damaged:

Fig 4: Identifying Door Retainer With Hinge And Thread

Courtesy of BMW OF NORTH AMERICA, INC.