51 12 050 Removing and installing/replacing carrier for rear bumper trim

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: During replacement, all the cavities of the carrier (1) and the crashbox (2) must be sealed with cavity sealant.

Fig 1: Identifying Carrier And Crashbox

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks

If necessary, release rubber mount (1) on carrier (2).

Unscrew nuts (3).

Remove carrier (2).

Tightening torque 51 12 1AZ .

Installation:

If necessary, replace faulty sheet nuts (4).

Replacement

If necessary, modify or replace weight on carrier (2).

Fig 2: Identifying Rubber Mount, Carrier, Nuts And Sheet Nuts

Courtesy of BMW OF NORTH AMERICA, INC.