51 71 447 Removing and installing/replacing trim for cover on left or right side member (up to 09/08)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Release screws (1).

Fig 1: Identifying Side Sill Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip panel (1) at holders (2) in direction of arrow and remove.

Fig 2: Removing Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Before installation, soak holders (1) in water.

If necessary, detach holders (1) from body and fit on panel (3).

If necessary, detach grommets (2) from holders (1) and place on body.

If necessary, replace faulty holders (1) and grommets (2).

Fig 3: Identifying Grommets And Holders

Courtesy of BMW OF NORTH AMERICA, INC.