51 11... Installing/replacing number/license plate (without base)

WARNING: This page is about a different variant/trim than selected.

NOTE: To obtain drilling template also refer to SI 00 11 09 (603).

Initial fitting

Place drilling hole template (1) on bumper (2).

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to car registration number plate specifications.

Remove template (1) and secure car registration number plate with screws provided.

Tightening torque 51 11 3AZ .

Fit protective caps.

Fig 1: Drilling Hole Template On Bumper

Courtesy of BMW OF NORTH AMERICA, INC.

Place drilling hole template (1) on radiator grille (2) and bumper (3).

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to car registration number plate specifications.

Remove template (1) and secure car registration number plate with screws provided.

Tightening torque 51 11 3AZ .

Fit protective caps.

Fig 2: Identifying Drilling Hole Template, Radiator Grille And Bumper

Courtesy of BMW OF NORTH AMERICA, INC.

Thread repair

Drill out defective hole in bumper (2) to 9.5 mm diameter.

Insert blind rivet nut (1).

Secure car registration number plate (3) with car registration number plate (4).

Tightening torque 51 11 4AZ .

Fig 3: Identifying Rivet Nut, Bumper And Car Registration Number Plate

Courtesy of BMW OF NORTH AMERICA, INC.