LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> M3 2D Convertible, Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 973 (Seats - Repair - E90) >> Front Seat, Sports, Electronic >> 52 16 405 Replacing backrest cover for left or right front seat (M3 sport seat)

52 16 405 Replacing backrest cover for left or right front seat (M3 sport seat)

WARNING: This page is about a different car, the 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required: 

See SEATS - SPECIAL TOOLS .

Necessary preliminary tasks: 

Unfasten plug connection (1) and disconnect.

Disconnect cable tie (2) for seat heating.

Disengage wiring harness for seat heating from cable holders on seat mechanism.

IMPORTANT: Feed the wiring harness carefully through the seat and backrest mechanism as the edges of the frame can be sharp.
Fig 1: Identifying Plug Connection And Cable Tie
G05779628Courtesy of BMW OF NORTH AMERICA, INC.

Detach backrest cover (1) from backrest frame.

Fig 2: Detaching Backrest Cover From Backrest Frame
G04727037Courtesy of BMW OF NORTH AMERICA, INC.

E90 only: 

Detach backrest cover in marked area.

Fig 3: Identifying Backrest Cover In Marked Area
G05779464Courtesy of BMW OF NORTH AMERICA, INC.

Padding is reinforced at corner points (1) and is guided under Bowden cable clip (2).

Installation: 

Engage reinforcement (1) in Bowden cable clip (2).

Fig 4: Identifying Cable Clip And Reinforcement
G06180878Courtesy of BMW OF NORTH AMERICA, INC.

Pull off backrest cover (1) with padding sideways and towards top from backrest frame (2).

Fig 5: Pulling Backrest Cover
G04742734Courtesy of BMW OF NORTH AMERICA, INC.

Loosen retainers (1).

Fold back welt (2) with backrest cover (3).

Fig 6: Identifying Retainers And Back Welt With Backrest Cover
G06180881Courtesy of BMW OF NORTH AMERICA, INC.

Release all retainers in marked area.

Remove backrest cover (1) from padding.

NOTE: Remove all remnants of retainers from backrest cover and padding.
Fig 7: Identifying Retainers In Marked Area
G04742735Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Bend new retainer (2) with special tool 52 0 050  .

  1. Padding
  2. Retainer
  3. Trim wire in padding
  4. Trim wire in backrest cover
  5. Backrest cover
Fig 8: Bending Retainer With Special Tool (52 0 050)
G04727043Courtesy of BMW OF NORTH AMERICA, INC.

Replacement of backrest cover: 

Pull trim wires (1) out of backrest cover.

Cut new backrest cover to size and insert trim wires (1).

Fig 9: Pulling Trim Wires Out Of Backrest Cover
G06180883Courtesy of BMW OF NORTH AMERICA, INC.