51 45 380 Removing and installing (replacing) right decorative strip on instrument panel
Special tools required:
- 00 9 317
See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .
IMPORTANT:
Risk of damage!
Do not turn special tool 00 9 317 when levering out and pay attention to pressure points.
Do not turn special tool 00 9 317 when levering out and pay attention to pressure points.
Lever out right decorative strip (2) from left side beginning at retaining points (1) with special tool 00 9 317 .
Disconnect associated plug connection and remove decorative strip (2).
Installation:
Clips (1) must be seated in associated mountings.
If necessary, remove clips (1) remaining on decorative strip.
Replace damaged clips (1):
- A Turn clip (1) with screwdriver to left by approx. 90°.
- B Lever out clip (1) from below.
Replacement:
- Remove Start/Stop switch . See 61 31 023 REMOVING AND INSTALLING/REPLACING START/STOP SWITCH .
- Remove switch for hazard warning system /central locking. See 61 31 079 REMOVING AND INSTALLING/REPLACING SWITCH FOR HAZARD WARNING FLASHERS/CENTRAL LOCKING .
- Remove right fresh-air grill . See 64 22 138 REMOVING AND INSTALLING/REPLACING RIGHT FRESH-AIR GRILL .
- Remove center fresh air grill . See 64 22 162 REMOVING AND INSTALLING/REPLACING CENTER FRESH-AIR GRILL .