51 47 000 Removing and installing/replacing front (inside) left or right entrance cover strip

Special tools required:

IMPORTANT: Do not raise entrance cover strip (1) over entire length simultaneously.

Using special tool 00 9 317 , unclip entrance cover strip (1) from clips (2) starting at rear and proceeding forwards.

Fig 1: Identifying Entrance Cover Strip And Clips

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, lever clips (1) out of floor pan (2) and attach to entrance cover strip.

Fig 2: Identifying Clips And Floor Pan

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty clips (1) on entrance cover strip (2).

Fig 3: Identifying Faulty Clips And Entrance Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.